HP DS2400 TO A K-CLASS SERVER

[HP RX4640]

Will the A3404A CARD WORK FOR THE APPLICATION OR WILL I NEED A6685A'S?

[mits]

You can check the supported system with the document below.

http://www.hp.com
-> Search A3404A
-> HP Fibre Channel Mass Storage
Adapters - Service and User Manual
-> page 31/94
Installing the A3404A Fibre Channel
Adapter on K-Class Systems

I have no expertise in application questions.

[mits]

I found a support matrix too.

http://docs.hp.com/
-> Internet & Networking
-> Networking and Communication
-> Fibre Channel
-> HP Fibre Channel Host Bus
Adapter Support Matrix

[Bernhard Mueller]

Jim,

never seen it but it should work (in direct connect) in arbitrated loop mode. the only thing to check or change is the setting of the link controller card speed in the DS (by default it is set to 2G/s). you would need to change that to 1G/sec. if you take out the LCC the DIP switch and setting is clearly visible.

Regards,
Bernhard