Disk Enclosures
1752794 Members
6686 Online
108789 Solutions
New Discussion юеВ

Re: HP Netraid part D4943-60002

 
Brian Berkley
Occasional Contributor

HP Netraid part D4943-60002

I have one of these controllers in a Windows 2000 server with 4mb cache module. Windows 2000 detects it as an AMI Megaraid card.

Is the cache upgradeable? What is the maximum memory I can put on it if it is? What type of memory does it take?

I've read that this controller is not compatible with Windows 2000, yet it is functioning fine in my system.

Thanks,

Brian
5 REPLIES 5
Vincent Fleming
Honored Contributor

Re: HP Netraid part D4943-60002

Yes, it's upgradable. You can

D6029A - 16MB SIMM Upgrade - Replaces existing 4MB SIMM in D4943A NetRaid Disk Array Controller - Do Not Mix 4MB and 16MB SIMMs (1 or 2 Used)

I got this via partsurfer at http://partsurfer.hp.com/cgi-bin/spi/main?prodsrch=D4943&sel_flg=modsrch&template=main

Look under Accessories.

You can order it directly from the website.

Good luck!
No matter where you go, there you are.
Brian Berkley
Occasional Contributor

Re: HP Netraid part D4943-60002

Is there a difference in the D4943 and D4943A? My controller specifically says:
HP Netraid D4943-60002.

Also, what's the scoop on updating the firmware on the card, and the fact that I see so much information on this site about the D4943 series not being compatible with Windows 2000?

kris rombauts
Honored Contributor

Re: HP Netraid part D4943-60002

Hi Brian,

their is only a D4943A which is it's official productnumber. D4943-60002 is it's part number, you'll find the same type of numbering accross all HP products.

The controller works on Windows 2000 but has never been officially tested/supported by HP on W2K. By the time W2K came out their were already other types of controllers out that performs much better and this card was already an older type by that time, so it made more sense to test and support newer cards.

Kris
Brian Berkley
Occasional Contributor

Re: HP Netraid part D4943-60002

Thanks!
Charlie Ruble_1
New Member

Re: HP Netraid part D4943-60002

Maybe you can help us.

We have the same card and have it installed in an LC3. The firmware is A.03.00. The system came with one ultra scsi drive and we had a couple of ultra2 scsi drives we want to put in. When the system boots up, it will see the original drive, but it won't see the new drives. The power lights on the ultra2 drives flick on, then immediately turn off. We're troubleshooting, but could use a little kick. Thanks.