HP P2000 G3 FC

[tarekamal]

I Have New SAN Storage P2000 G3 FC Dual Controller, connected to the servers through SAN Switch 8/8 Fc, The Problem is I can't find any Tape Drive in the Host Server or No SAN Storage Detected.

[Torsten.]

You need to create vdisks and volumes, create or discover hosts, set host profiles and present the volumes to hosts.

Did you do this?

[tarekamal]

Yes

[tarekamal]

I install the MPIOin the host server, and I asked through the wizard to ably the Vendor & Product IDs., and I find it installaed with "HP     MSA2"

[tarekamal]

Is there any Document availabe to Install and attached the SAN Storage to the Host Server.

[Johan Guldmyr]

You also need to zone the P2000 with the host.

You're not going to see any Tape Drives presented from the P2000.

[Torsten.]

Since the server cannot see the P2000 and the tape drive, the problem is likely on the switch. Did you do the "cfgenable"?

Consider to post from the switch (telnet connection):

# switchshow

# zoneshow