Disk Arrays
cancel
Showing results for 
Search instead for 
Did you mean: 

HP P2000 G3 MSA FC. Vdisk verification failed. Scrub failed on vdisk

pub10
Occasional Visitor

HP P2000 G3 MSA FC. Vdisk verification failed. Scrub failed on vdisk

After a power failure got three problems:

1)
Vdisk verification failed. Command failed. (error code: 1) 1 error(s) were found. (vdisk: vDisk01, SN: 00c0ff112a45000014fd5c4d00000000)
2) Scrub failed on vdisk: vDisk01 SN: 00c0ff112a45000014fd5c4d00000000 Number of parity mismatches found: 1. If a disk fails data may be at risk. Action required: See the Event Descriptions Reference Guide for the recovery procedure.

3) network port on one of the controller does not work

 

How can I fix these errors?

 

 

P.S. This thread has been moved from HP Support Center (Website) Feedback & Suggestions to Disk Arrays. - Hp Forum Moderator

3 REPLIES
Zsal
HPE Pro

Re: HP P2000 G3 MSA FC. Vdisk verification failed. Scrub failed on vdisk

I see two issues here: Vdisk and Network port issue. You need to use the verify-fix utility to fix the vdisk issue.

 

CAUTION: The logs need to be thoroughly checked to rule out any hardware defect on any of the disks. Running verify-fix without doing this check could lead to massive data loss.
 
It is recommended to contact HP support to perform the above procedure.
 

Hope this helps!!

 

Regards

Zsal

 

 
pub10
Occasional Visitor

Re: HP P2000 G3 MSA FC. Vdisk verification failed. Scrub failed on vdisk

 i need to update the firmware . Now I have a version TS201P004. Support said that it is necessary to upgrade to TS230P008, and then to version TS251P006-02 . But where is 230p008 on this website? http://h20564.www2.hp.com/hpsc/swd/public/readIndex?sp4ts.oid=5111379&swLangOid=8&swEnvOid=4064

There's only 251p006-02...




Jan Soska
Honored Contributor

Re: HP P2000 G3 MSA FC. Vdisk verification failed. Scrub failed on vdisk