HP VA7100 CLI reference guide

[Patrick Terlisten]

Hello,

I'm searching for a CLI reference for the HP VA storage arrays? Is there any PDF?

Regards,
Patrick

[Torsten. · Accepted solution]

I don't remember if there was any.

I normally used the VFP CLI for creating LUN0 and very basic troubleshooting only.
Better to use command view.


You can get basic help like this:

Ready > help

For help with a command, use the -? option (e.g. vfpsetup -?).

setup Performs Virtual Front Panel configuration.
dsp Displays subsystem status.
cfg Performs subsystem configuration.
mgr Performs subsystem management operations.
fmt Performs a subsystem format.
rbld Performs rebuild operations.
recover Performs NVRAM recovery operations.
secure Performs LUN Security operations.
log Displays event logs



Ready > dsp -?



Displays subsystem status.


Usage:

dsp [-c ] [-d ] [-e ] [-f]

[-L ] [-s] [-?]


-c: Displays controller information.

-d: Displays disk information.

-e: Displays enclosure information.

-f: Displays a listing of FRUs in the array.

-L: Displays LUN information.

-s: Displays subsystem status, warnings, and

subsystem parameter information for the array.

-?: Displays help.





Or are you looking for command view cli commands? They are all in the CV SDM user guide.

[Patrick Terlisten]

Hello,

my fault, I searched for a CLI guide, but the arm-commands were in the CV SDM guide. Thanks for that hint!

http://www.dectrader.com/docs/set3/c00300018.pdf

Regards,
Patrick

[Torsten.]

Found something deep inside the directory tree ... see attachment.

[Torsten.]

Ok, you searched for CV SDM arm commands.

If unsure about usage, try cvui. The command line used for the selected command is printed at the bottom of the screen.