Disk Enclosures
1748041 Members
5203 Online
108757 Solutions
New Discussion юеВ

HPUX 11.00: HP V2600 vpath configuration IBM ESS Shark

 
LG Porter
Frequent Advisor

HPUX 11.00: HP V2600 vpath configuration IBM ESS Shark

I have a HP V2600 server running HPUX 11.00 attached to a IBM ESS (Shark). I'm experiencing a issue with getting the server to configure the vpaths upon reboot as well as the "vgchange -a y" command seems to hang up while attempting to manually activate the volume groups. As anyone seen this problem with IBM Shark attached to HP server?
3 REPLIES 3
John Payne_2
Honored Contributor

Re: HPUX 11.00: HP V2600 vpath configuration IBM ESS Shark

Is this SCSI or Fibre? Has this ever worked for you yet, or are you at the initial setup stage of this?

Connecting to the Shark is a pain in the rear. You have to make sure you are using supported 'everything', and that your firmware is at something near current for each piece down the line.

John
Spoon!!!!
Prashant Zanwar_4
Respected Contributor

Re: HPUX 11.00: HP V2600 vpath configuration IBM ESS Shark

http://www.dutchworks.nl/htbin/hpsysadmin?h=3&dn=96742&q=IBM%20Shark&fh

This might prove helpful.
Thanks
Prashant
"Intellect distinguishes between the possible and the impossible; reason distinguishes between the sensible and the senseless. Even the possible can be senseless."
LG Porter
Frequent Advisor

Re: HPUX 11.00: HP V2600 vpath configuration IBM ESS Shark

FYI.....

The resolution to this issue was that we had to perform a "Save State Reset" on the ESS (Shark) in order to reinitialize all the fiber channel adapters and disks. Once it was complete, the V2600 could then see all the disks....Hope this helps...thanks