How do you Back and Retore the Config

[Ayman Altounji]

I remember reading somewhere that you can backup the configuration of the array on floppy disk. Then when the M.Board is swapped out and a new M.Board installed (with a new controller) you can read in the config from the floppy.

Any info??

[Ayman Altounji]

I never seen a Option to do a Config Backup of the Array Kontroller on floppy.
But on some Servers you can save the Board Config on floppy.

The Array Config is stored in the Array Kontroller, on Disk an on Board, if you change one after the other, you may hav no problem.
If you must change 2 at one time, be sure that the Board and Kontroller have no Configuration before (Systemerase).