- Community Home
- >
- Storage
- >
- Entry Storage Systems
- >
- Disk Enclosures
- >
- Re: MDS600 with P711M controller: how to monitor i...
Categories
Company
Local Language
Forums
Discussions
Forums
- Data Protection and Retention
- Entry Storage Systems
- Legacy
- Midrange and Enterprise Storage
- Storage Networking
- HPE Nimble Storage
Discussions
Discussions
Discussions
Forums
Forums
Discussions
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
- BladeSystem Infrastructure and Application Solutions
- Appliance Servers
- Alpha Servers
- BackOffice Products
- Internet Products
- HPE 9000 and HPE e3000 Servers
- Networking
- Netservers
- Secure OS Software for Linux
- Server Management (Insight Manager 7)
- Windows Server 2003
- Operating System - Tru64 Unix
- ProLiant Deployment and Provisioning
- Linux-Based Community / Regional
- Microsoft System Center Integration
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Community
Resources
Forums
Blogs
- Subscribe to RSS Feed
- Mark Topic as New
- Mark Topic as Read
- Float this Topic for Current User
- Bookmark
- Subscribe
- Printer Friendly Page
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
тАО07-27-2012 02:04 PM
тАО07-27-2012 02:04 PM
I read this in documentation:
Receive pre-failure alert's with HP SIM. When drives installed in a MDS600 are used in conjunction with a SMART Array Controller and Systems Insight Manager, the SMART capable firmware in HP hard drives enables extensive fault prediction capabilities.
Does anyone out there monitor their c7000 blades, servers and their HP MDS600 arrays through SIM? I have gone through all the documents, release notes, etc and find nothing that will tell me how to use the SMART Array Controller to report pre-failure alerts. I thought the disk array forum might give me better response from people that actually use the MDS600.
Regards,
Alice
Solved! Go to Solution.
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
тАО08-23-2012 03:08 PM
тАО08-23-2012 03:08 PM
SolutionI responded to your other post as well, but in a nutshell --
Install HP management agents on servers connected to MDS
Discover servers in SIM
Wait for hardware event to occur (failed drive)
Storage Agent on server sends trap to SIM
SIM opens support case with HP via Remote Support Advanced
HP verifies via phone call/email that event was legit
HP ships replacement drive or sends technician
Failed drive is replaced and controller rebuilds logical drive (RAID)
Everyone hi-fives that monitoring & alerting works as expected
kind regards,
-b
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
тАО09-03-2015 04:25 AM
тАО09-03-2015 04:25 AM
Re: MDS600 with P711M controller: how to monitor in system insight manager
How to configure agent to send trapto specified ip?