HPE Community
Disk Enclosures
1752284 Members
4449 Online
108786 Solutions
New Discussion

MSA1000 not showing new drives

 
fbadmin
Occasional Contributor

‎09-10-2010 07:47 AM

‎09-10-2010 07:47 AM

MSA1000 not showing new drives

WE have a MSA1000 with 2 san bays. we added 4 300gb drives to san bay 2. When i type "show disks" it showed all 4 drives. after raiding 2 of the 4 drives and tried to raid the second pair but was unable to stating that they didnt have enough space. When i pulled the drives out to reseed them is when i ran into the msa not showing the drives anymore.

Anybody have any ideas why after i reseeded the drives that neither controller 1 or 2 will show the drives? is their a command to rescan the drives that i dont know about?
0 Kudos
1 REPLY 1
fbadmin
Occasional Contributor

‎09-10-2010 09:10 AM

‎09-10-2010 09:10 AM

Re: MSA1000 not showing new drives

we couldnt figure it out but instead we rremoved the raid from the first 2 drives. once we did that it showed all 4 drives again. WE then raided the 2 drives that didnt show up before first then the other 2 and all is good.
0 Kudos
The opinions expressed above are the personal opinions of the authors, not of Hewlett Packard Enterprise. By using this site, you accept the Terms of Use and Rules of Participation.