- Community Home
- >
- Storage
- >
- Entry Storage Systems
- >
- Disk Enclosures
- >
- MSA20 - replaced drive
Categories
Company
Local Language
Forums
Discussions
Forums
- Data Protection and Retention
- Entry Storage Systems
- Legacy
- Midrange and Enterprise Storage
- Storage Networking
- HPE Nimble Storage
Discussions
Discussions
Discussions
Forums
Discussions
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
- BladeSystem Infrastructure and Application Solutions
- Appliance Servers
- Alpha Servers
- BackOffice Products
- Internet Products
- HPE 9000 and HPE e3000 Servers
- Networking
- Netservers
- Secure OS Software for Linux
- Server Management (Insight Manager 7)
- Windows Server 2003
- Operating System - Tru64 Unix
- ProLiant Deployment and Provisioning
- Linux-Based Community / Regional
- Microsoft System Center Integration
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Community
Resources
Forums
Blogs
- Subscribe to RSS Feed
- Mark Topic as New
- Mark Topic as Read
- Float this Topic for Current User
- Bookmark
- Subscribe
- Printer Friendly Page
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
01-03-2012 06:08 AM
01-03-2012 06:08 AM
MSA20 - replaced drive
Hi all,
i logged call with HP support and had the predicted drive for failure replace. It rebuilt two of the 4 arrays, and is now stuck with "Ready for Recover" and not proceeding further.
Attached is the HP ACU report.
Please advise as i am stuck with what to do. can the remaining two volumes not be forced for recovery.
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
01-11-2012 08:21 AM
01-11-2012 08:21 AM
Re: MSA20 - replaced drive
Hi There,
The logical drive is queued for rebuilding generally seen on MSA when controller is busy rebuilding another drive or another logical drive is being rebuilt and status yet to be refreshed. Would suggest you to wait for sometime and refresh the status from ACU.
If status does not change then validate your backup/ backup the information and try the following steps:
1. backup the data if required.
2. Power cycle the devices (power-off the server first, then the MSA. While powering ON Power on the MSA and wait for MSA to initialized then power on the server).
3. A POST message will appear when the system is next powered up. This message prompts you to press the F1 key to start automatic data recovery. start the data recovery process by pressing the F1 key and monitor the status.
Note: If you do not enable automatic data recovery, the logical volume remains in a ready-to-recover condition and the same POST message appears whenever the system is restarted.
Hope this helps,
thanks,
Aftab
For more information on disk / Array troubleshooting, please refer to HP Guided Troubleshooting (www.hp.com/support/hpgt)
How to assign points on this new forum? Click the Kudos Star!
ITRC Style Sitemap.
Looking for a quick resolution to a technical issue for your HPE products? HPE Support Center Knowledge-base – Just a Click Away!
See Self Help Post for more details