MSA30 smart array 6402 disk replace

[tareq_2]

hi there
i have MSA30 smart array 6402 with three failed disk i want to replace this disks with new three disk. what i can do? is just plug it in the enclosure or i need to do something else
this MSA is connect to hpux in rp 7420 server.

any help please.

[Torsten.]

Does

# sautil /dev/ciss...

really say all the disks are failed?

[tareq_2]

hi Torsten
this is the output of the sautil

[tareq_2]

and this is the saconfig output
please find the attached file

[Torsten. · Accepted solution]

Looks like there is only 1 disk (ID 9) dead, but both batteries too.

You can just swap this disk.

[tareq_2]

ok but i have three disk with red light what i do after i replace the disk , just put it .
or i need to run some command.

[Torsten.]

According to the output you have 8 disks, 1 failed. What disks are red?

Just swap the disk (ID 9) and check again with sautil, the drive should be rebuilding.

[tareq_2]

ok i will swap the faild disk with new one.
but what about batteries the both are faild.
what i can do for it . i think i need to update the firmware for the controller.
is that correct?
thank you for your help

[Torsten.]

A failed battery is failed and need to be replaced. Checking the firmware is also a good idea ...

[tareq_2]

thanks for usefull help