Disk Arrays
cancel
Showing results for 
Search instead for 
Did you mean: 

NVSRAM checksum does not match

Printaporn_1
Esteemed Contributor

NVSRAM checksum does not match

Hi,

FC60 from command amdsp -c , I found that NVSRAM checksum in controller A and controller B , does not match , does it would be the problem ?
I got EMS message:
Array at hardware path 0/5/0/0.8.0.5.0.0.0, path 0/4/0/0.8.0.4.0.0.0: Both controllers may not have the same RAM image.
There is a loss of NVRAM redundancy.
Associated OS error log entry id(s):
0000000000000000000

Latest information on this event:
http://docs.hp.com/hpux/content/hardware/ems/fc60mon.htm#9

Description of Error:
This event message is displayed when the mirroring hardware is unable
to keep the two RAM images synchronized across the two controllers.

Probable Cause / Recommended Action:
Investigate the hardware log and use other warning conditions as a
guide to the problem. You may need to replace the controller.

Possible Causes Include:
1. A controller has failed, but no obvious failure mode is evident.
2. A controller is not communicating at all.

---------------
I check all Hardware error log , using mstm , logtool , but no error reported and array can working as normal.
enjoy any little thing in my life
1 REPLY
harry d brown jr
Honored Contributor

Re: NVSRAM checksum does not match

Assuming you have the latest patch bundles, I'd place a call to HP. It sounds like your array took some kind of hit. good luck.

harry
live free or die
Live Free or Die