- Community Home
- >
- Storage
- >
- Entry Storage Systems
- >
- Disk Enclosures
- >
- P2000 MSA
Categories
Company
Local Language
Forums
Discussions
Forums
- Data Protection and Retention
- Entry Storage Systems
- Legacy
- Midrange and Enterprise Storage
- Storage Networking
- HPE Nimble Storage
Discussions
Discussions
Discussions
Forums
Discussions
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
- BladeSystem Infrastructure and Application Solutions
- Appliance Servers
- Alpha Servers
- BackOffice Products
- Internet Products
- HPE 9000 and HPE e3000 Servers
- Networking
- Netservers
- Secure OS Software for Linux
- Server Management (Insight Manager 7)
- Windows Server 2003
- Operating System - Tru64 Unix
- ProLiant Deployment and Provisioning
- Linux-Based Community / Regional
- Microsoft System Center Integration
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Community
Resources
Forums
Blogs
- Subscribe to RSS Feed
- Mark Topic as New
- Mark Topic as Read
- Float this Topic for Current User
- Bookmark
- Subscribe
- Printer Friendly Page
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
09-24-2012 06:34 AM
09-24-2012 06:34 AM
P2000 MSA
I'm having an issue with a P2000 MSA iSCSI. I'm not sure if it's a G3 or an earlier one. However, the issue is the unit is in our test lab. We've recently acquired it, however, we also know nothing about the configuration. LUNs, vdisks, IP addresses, usernames and passwords, etc.
I want to reset it to the factory defaults, however, the only method I see is to gain access via the CLI. Of course, we don't have the cable that shipped, and I"m not 100% sure the admin password hasn't been changed.
So, my question is: "Is there any way to reset the unit to factory defaults without accessing the CLI? Can I use the service port/pushbutton on back? I'm not the least bit worried about losing data; it exists in our lab environment only, nothing production on it.
Appreciate any help I can get.. I haven't had a lot of luck looking through the documentaiton.