HPE Community
Disk Enclosures
1753338 Members
5155 Online
108792 Solutions
New Discussion

Problem with replaced Drive in 431 Controller

 
Arthur Messner
Occasional Contributor

‎03-17-2003 05:54 AM

‎03-17-2003 05:54 AM

Problem with replaced Drive in 431 Controller

After a Disk Failure, in a 5 Disk ( 5*72 Gb ) Raid 5 Array on a Smart Array 431 Controller in a Proliant 1600, i replaced the drive. The new drive was immediately rebuilding, as it should, but after 100% completion, the Insight Manager showed the Process bar falling to 70% and after a couple of minutes, the drive was in "Ready to rebuild state". The Drive Led on this Disk was off. I tried it with another disk, but it was almost the same.
0 Kudos
Reply
The opinions expressed above are the personal opinions of the authors, not of Hewlett Packard Enterprise. By using this site, you accept the Terms of Use and Rules of Participation.