1748288 Members
3381 Online
108761 Solutions
New Discussion юеВ

RAID 0 ON FC60

 
SOLVED
Go to solution
Ray Estevez
Occasional Contributor

RAID 0 ON FC60

I need to know if I can setup RAID 0 on my new FC60 w/ 12x 18 GB drives. HP engineers installed and set this up without asking us what we really wanted. The SAM utility does not allow me to select RAID 0. When I try this from command line, I get the following error message:
amcfg -L A:1 -d 1:1,2:1 -r 0 -s 16 fc60

Out put from amcfg:
amcfg: Arg out of range

So, is there a way that we can just use RAID0 for binding LUN?
Also, I read somewhere that I may need the latest firmware hp08 to support RAID 0. It appears we currently have firmware version HP04. Is this true?

3 REPLIES 3
Kostas Labroussis
New Member

Re: RAID 0 ON FC60

Unfortunatelly as far as i know you will never be able to
bind a Lun with raid level 0.

You can bind lun's with either 1 and 5 raid level (0/1 will be automatically selected when creating a raid 1 with more than two disks) but you cannot bind a lun with raid
0.

See User's Guide page # 158 "Binding a Lun"

regards,
Kostas.
Insu Kim
Honored Contributor

Re: RAID 0 ON FC60

Please notice a patch released recently and it explains RAID 0 for FC60.
See the patch text.

Patch :
10.X PHCO_23148
11.X PHCO_23149

Hope this helps,
Never say "no" first.
Bob Inglis
Trusted Contributor
Solution

Re: RAID 0 ON FC60

At the current release of firmware, only RAID 0/1, RAID 1 and RAID 5 are supported.

firmware HP03 is the current HPUX release

firmware HP04 is the current Windows NT release

firmware HP08 has been recalled

Please do not be confused by the disk enclosure controler firmware. The above firmware is for the Array controler only.
Plan for the future and tomorrow will take care of itself.