HPE Community
Disk Enclosures
1753877 Members
7613 Online
108809 Solutions
New Discussion юеВ

RIS copies between drives fo not match

 
Steve Patterson
New Member

тАО02-17-2003 09:59 AM

тАО02-17-2003 09:59 AM

RIS copies between drives fo not match

I'm using an MSA1000 array and getting the message "RIS copies between drives fo not match" in the diagnostic utility. I can't find any info about this anywhere. Any ideas?
0 Kudos
Reply
2 REPLIES 2
Steve Patterson
New Member

тАО02-17-2003 10:02 AM

тАО02-17-2003 10:02 AM

Re: RIS copies between drives fo not match

Sorry. My bad. It's "RIS copies between drives do not match".
0 Kudos
Reply
Steve Patterson
New Member

тАО02-17-2003 01:18 PM

тАО02-17-2003 01:18 PM

Re: RIS copies between drives fo not match

I found the issue. It was because I had unconfigured disks in the SAN. The configured logical drives had one RIS and the unconfigured disks had a different RIS. When I configured the spare disks into logical arrays, the message went away.
0 Kudos
Reply
The opinions expressed above are the personal opinions of the authors, not of Hewlett Packard Enterprise. By using this site, you accept the Terms of Use and Rules of Participation.