- Community Home
- >
- Storage
- >
- Entry Storage Systems
- >
- Disk Enclosures
- >
- Redundancy
Disk Enclosures
1748288
Members
3438
Online
108761
Solutions
Forums
Categories
Company
Local Language
back
Forums
Discussions
Forums
- Data Protection and Retention
- Entry Storage Systems
- Legacy
- Midrange and Enterprise Storage
- Storage Networking
- HPE Nimble Storage
Discussions
Discussions
Discussions
Forums
Discussions
back
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
- BladeSystem Infrastructure and Application Solutions
- Appliance Servers
- Alpha Servers
- BackOffice Products
- Internet Products
- HPE 9000 and HPE e3000 Servers
- Networking
- Netservers
- Secure OS Software for Linux
- Server Management (Insight Manager 7)
- Windows Server 2003
- Operating System - Tru64 Unix
- ProLiant Deployment and Provisioning
- Linux-Based Community / Regional
- Microsoft System Center Integration
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Blogs
Information
Community
Resources
Community Language
Language
Forums
Blogs
Topic Options
- Subscribe to RSS Feed
- Mark Topic as New
- Mark Topic as Read
- Float this Topic for Current User
- Bookmark
- Subscribe
- Printer Friendly Page
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
02-20-2001 04:00 PM
02-20-2001 04:00 PM
Redundancy
I recently setup a Proliant 8000 using a 4250es controller.
There are 7 -18gb drives total. Array A consists of 3 -18gb drives using RAID 5. Array B consists of 3 -18gb drives with a 4th used as an on-line spare.
My question is as follows. Can I add a second 4250es
controller for redundancy without erasing the current configuration?
If so, what steps do I need to take?
There are 7 -18gb drives total. Array A consists of 3 -18gb drives using RAID 5. Array B consists of 3 -18gb drives with a 4th used as an on-line spare.
My question is as follows. Can I add a second 4250es
controller for redundancy without erasing the current configuration?
If so, what steps do I need to take?
1 REPLY 1
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
04-03-2001 04:00 PM
04-03-2001 04:00 PM
Re: Redundancy
Sure - install the second controller in the slot right next to the original 4250ES, run setup and then load the redundancy driver from the NT 4.0 SSD:
NT 4.0 SSD
NT 4.0 SSD
The opinions expressed above are the personal opinions of the authors, not of Hewlett Packard Enterprise. By using this site, you accept the Terms of Use and Rules of Participation.
News and Events
Support
© Copyright 2024 Hewlett Packard Enterprise Development LP