HPE Community
Disk Enclosures
1752628 Members
5856 Online
108788 Solutions
New Discussion

SC10 BCC Tray ID's

 
Sally Devine
Frequent Advisor

‎12-04-2001 08:05 AM

‎12-04-2001 08:05 AM

SC10 BCC Tray ID's

Can anyone tell me if the tray id's on the bcc's are to be the same or different. I have two bccs and they are both set to 0. I am having problems with these disks and I think that may be why, but want to confirm.

Thanks,
Sally
0 Kudos
Reply
1 REPLY 1
Bill McNAMARA_1
Honored Contributor

‎12-04-2001 10:04 AM

‎12-04-2001 10:04 AM

Re: SC10 BCC Tray ID's

what are the jumpers set to.
This will determine if you're in split bus mode or full bus mode.

If you're in full bus mode the dials should be different if you're in JBOD mode... but in array mode, ie you're in an FC60 they should be the same, in which case the cabling is more important than the dials.

Confusing?

Later,
Bill
It works for me (tm)
0 Kudos
Reply
The opinions expressed above are the personal opinions of the authors, not of Hewlett Packard Enterprise. By using this site, you accept the Terms of Use and Rules of Participation.