Secure Path 4.0 and HSG80 Problem

[axlr8fullrpm]

After installing Secure Path 4.0c, all disk appeared to be Compaq Secured Path Disk. One more problem that i am going to consult is the 4 virtual disk that i created are also visible to other host, i checked the zoning on the switch and the zoning config is correct, only the hosts that i wanted to access the virtual disk are defined. What could possibly cause the problem?

[Håkan Persson_1]

Have you set access rights in the HSG80 ?
When you create a new unit the default setting is that all host have access to it,
so you have to the following:

SET Dxx DIS=ALL ENA=(connectionname1, connectionname2, connectionname3, connectionname4)
Replace xx with the unitnumber, and connectionname with the name of your connections.

[axlr8fullrpm]

I already did a selective access on SWCC but it is still appearing on the unselected host.

[Håkan Persson_1]

Have you restarted the other server since you set the access rights ? Don't think it disappears until you do that if it has been accessible.

[axlr8fullrpm]

Problems were solved by reinstalling Secure Path. Thanks a lot guys!!!