Disk Arrays
cancel
Showing results for 
Search instead for 
Did you mean: 

Solid green and solid amber LEDs on drive, but OK status in SMU

SOLVED
Go to solution
dbean
Occasional Visitor

Solid green and solid amber LEDs on drive, but OK status in SMU

I have a new P2000 G3 12-disk array and after a power outage this weekend I have one drive showing solid green and amber LEDs, but everything in the SMU shows OK. Solid green + solid amber is not a condition shown in the reference guide so I'm not sure if I actually have a problem.

 

Any advice would be greatly appreciated.

2 REPLIES
AnkitM
Trusted Contributor

Re: Solid green and solid amber LEDs on drive, but OK status in SMU

If the Disk is not a part of any vdisk.
Reseat the disk and verify if the LED Status is the same.
If yes, if you have any empty slot you can verify if the disk has the issue or not.

If yes, contact HP Technical Support for the Proactive Disk Replacement.


Moreover, if disks has issue it should have generated events for the same disks.

 

 

Was your question answered correctly? If so, please remember to mark your question Answered when you get the correct answer and award KUDOS! to the person providing the answer. This helps others searching for a similar issue.
dbean
Occasional Visitor
Solution

Re: Solid green and solid amber LEDs on drive, but OK status in SMU

Thanks for the feedback. I ended up talking to HP and we powered down the servers, msa, and controllers, then rebooted everything and the amber status went away. All the logs were clean so it appeared to be a false error report.