VA7100 Disk replacement

[anoop_10]

Hi,
We have one VA 7100, one of its disks got failed and I replaced it. But I don't know how to check, is it working fine or not. I just unplugged the def. HDD and fixed the new HDD .Is there any command to run for including this disk in VA logical units and am not aware from which logical units it got failed.
Here am attaching the logs after replacing the disk.
Please help me...

[anoop_10]

I have replaced
Disk at M/D5:

Disk at M/D5:
Status:_______________________________Good
Disk State:___________________________Previously used
Vendor ID:____________________________HP 73.4G
Product ID:___________________________ST373307FC
Product Revision:_____________________HP03
Data Capacity:________________________66.757 GB (140000000 blocks)
Block Length:_________________________520 bytes
Address:______________________________115
Node WWN:_____________________________2000000c5025e1d7
Initialize State:_____________________Ready
Redundancy Group:_____________________65536
Volume Set Serial Number:_____________0000590A00000010
Serial Number:________________________3HZ1ADN4
Firmware Revision:____________________HP03

Disk at M/D6:
Status:_______________________________Good
Disk State:___________________________Included
Vendor ID:____________________________HP 73.4G
Product ID:___________________________ST373307FC
Product Revision:_____________________HP00
Data Capacity:________________________66.757 GB (140000000 blocks)
Block Length:_________________________520 bytes
Address:______________________________116
Node WWN:_____________________________20000004cf1de9af
Initialize State:_____________________Ready
Redundancy Group:_____________________1
Volume Set Serial Number:_____________000050FA00000009
Serial Number:________________________3HZ0RQ6W
Firmware Revision:____________________HP00
Recovery Maps are on this disk.

[anoop_10]

I have repalced only one disk

disk at M/D5

[Patrick Wallek · Accepted solution]

What is the overall status of the array? Since the disk shows to be previously used you will probably have to manually "include" it. This can be done from the CommandView GUI or from the command line.

An 'armcfg -D M/D5 -a ' may do it. I can't recall exactly. You may want to check the armcfg man page yourself.

[Torsten.]

Hi,

your M/D5 disk is not yet included.
Use commandview (cvui or GUI) to include the disk.

Check the status with

armdsp -a array_alias

[anoop_10]

Hi,

I have successfully included the disk using the command.

armcfg -D -a

Thanks for your support...

Anoop