VA7100 virtual array problem

[nasimuddin ansari]

Our VA7100 virtual array storage gives following problem.

Warning Status> dsp

Arrany Information
Array World Wide Name : 0x50060b0000092c10
Alias:
Array Status: Warning state

WARNINGS
--------
Data Unavailable
Redundancy Loss
Hot Spare Unavailable
Capacity Deplition
Rebuild Failed
Catastoropic Redundancy loss
Missing Drive
Recovery Failed
Sigle Controller
No Map Disks

controller Encloser Information
-------------------------------
Serial No 00SG205G0066
status summery OK

Any clue apprecaiated. Is my LLC(RAID controller need replacement?

[freddy_21]

could you see your disk how many disk failed at your box?


thanks
freddy

[nasimuddin ansari]

We have totak 04 disk.
All four are showing "not-included".

[freddy_21]

wow all disk not detect at your server?

I not sure about your data. please contact HP technical support for trobleshooting this case.



thanks
Freddy

[Torsten.]

According to your other thread I assume this is a new setup. If this is the case and you have no data on the array, just format it and the errors will go away. Is there only one controller in the box?

[freddy_21]

If you dont care about your data, please reset one controller and look at vgfdsp.

Open the screw at your one controller and detach the hook. wait a few minutes after that reattach the hook.

Thanks
Freddy

[nasimuddin ansari]

We have formated the controller. Created fresh LUNs and restored data.
Thanks to all of you

[freddy_21]

when you format VA7100, you not replace anything? please upgrade the firmware for controller and the disk.

then new firmware for controller is HP22.
battery firmware : Version 4.3

For disk depend on your string ID for each disk

ex; ST318453FC HP05


thanks
freddy