VA7400 and DS2405

[Daniel Fourie]

Hi!

I have got a VA7400 and have connected a DS2405 to it. I would like to know how to configure the DS2405 to work with the VA7400.

I am using "command view sdm" and in command view I can see my VA7400 but not my DS2405.

Please Help
Regards

P.S. This thread has been moved from General  to Disk array. - Hp Forum Moderator

[Joshua Scott · Accepted solution]

Make sure the Controller cards on the ds2405 are set to 1 Gb/s. you'll have to pull the controller cards out, and set this via dipswitch.

If this doesn't correct the problem, reply back and i'll post the full instructions for installing a new enclosure.

[Joshua Scott]

Just in case, here's the instructions from the users guide (see attached)