- Community Home
- >
- Storage
- >
- Entry Storage Systems
- >
- Disk Enclosures
- >
- VA7410 Mismatched Code
Disk Enclosures
1745937
Members
3935
Online
108723
Solutions
Forums
Categories
Company
Local Language
back
Forums
Discussions
Forums
- Data Protection and Retention
- Entry Storage Systems
- Legacy
- Midrange and Enterprise Storage
- Storage Networking
- HPE Nimble Storage
Discussions
Discussions
Discussions
Forums
Discussions
back
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
- BladeSystem Infrastructure and Application Solutions
- Appliance Servers
- Alpha Servers
- BackOffice Products
- Internet Products
- HPE 9000 and HPE e3000 Servers
- Networking
- Netservers
- Secure OS Software for Linux
- Server Management (Insight Manager 7)
- Windows Server 2003
- Operating System - Tru64 Unix
- ProLiant Deployment and Provisioning
- Linux-Based Community / Regional
- Microsoft System Center Integration
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Blogs
Information
Community
Resources
Community Language
Language
Forums
Blogs
Topic Options
- Subscribe to RSS Feed
- Mark Topic as New
- Mark Topic as Read
- Float this Topic for Current User
- Bookmark
- Subscribe
- Printer Friendly Page
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
07-16-2009 08:24 AM
07-16-2009 08:24 AM
VA7410 Mismatched Code
When I connect serially to the VA7410, the prompt I get is Mismatched Code>
I have tried to display the two controllers with the dsp -d 1/2 and it returns "Controller Not Present". The command dsp -d returns "No disks present" Yet there are 14 disks in the array. I can't seem to figure this out. I have the host port connected to a HP-UX box and when I try to use CommandView armdiscover, I can see the fibre host port blink so it is talking to it but CommandView cannot see it. Any thoughts?
I have tried to display the two controllers with the dsp -d 1/2 and it returns "Controller Not Present". The command dsp -d returns "No disks present" Yet there are 14 disks in the array. I can't seem to figure this out. I have the host port connected to a HP-UX box and when I try to use CommandView armdiscover, I can see the fibre host port blink so it is talking to it but CommandView cannot see it. Any thoughts?
1 REPLY 1
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
07-16-2009 11:57 PM
07-16-2009 11:57 PM
Re: VA7410 Mismatched Code
Hello,
where did you get this system? Are both controller okay? Did you an firmware update?
Best regards,
Patrick
where did you get this system? Are both controller okay? Did you an firmware update?
Best regards,
Patrick
Best regards,
Patrick
Patrick
The opinions expressed above are the personal opinions of the authors, not of Hewlett Packard Enterprise. By using this site, you accept the Terms of Use and Rules of Participation.
News and Events
Support
© Copyright 2024 Hewlett Packard Enterprise Development LP