evaperf for EVA3000

[tkc]

can anyone tell me if we can use evaperf for EVA3000 controller (HSV100) running with firmware revision 3.010 ?

[tkc]

i have downloaded the evaperf software from :

http://h20000.www2.hp.com/bizsupport/TechSupport/SoftwareIndex.jsp?lang=en&cc=us&prodNameId=1833644&prodTypeId=12169&prodSeriesId=471497&swLang=13&taskId=135&swEnvOID=1005

didn't find any info about whether it can support EVA3000 controller firmware revision 3.010

[TY 007]

Hello,

What is the Commandview Software version?

Thanks

[tkc]

It's HP StorageWorks Command View EVA V3.1

[Uwe Zessin]

EVAperf was made available during the Command View V4.1 timeframe. As it does not depend on CV, there is some chance that it works if you can get hold of the old kit.

[tkc]

i tried to search for older evaperf and got this info :

http://h20000.www2.hp.com/bizsupport/TechSupport/Document.jsp?lang=en&cc=us&objectID=c00578056&jumpid=reg_R1002_USEN

it mentioned it will support controller with firmware 3.028. so i am wondering if anyone who has used evaperf with firmware 3.010 or below before.

[Mark Poeschl_2]

I'm sure this will come back from HP as an "unsupported" configuration - not to mention the fact that I came across some "known bugs" in earlier versions of EVA Perf that caused certain statistics to be mis-reported. So: you may well be able to get your configuration to run and even produce what looks like good output, but I wouldn't trust its accuracy at all.

[whiteknight]

TKC,

3.010 is very old, you should be planning to upgrade to 3110 ?

evaperf is is part of the Command view install, only issue I don't think 3.010 is supportd with 6.02.

WK

[tkc]

ya, upgrading the firmware is one of my option but not now. i wish to check if anyone can get evaperf working with 3.010. if so, i can give it a try though there's no support statement from hp.

[Rob Leadbeater]

Hi,

I seem to recall there being changes to the metadata structure on an EVA between VCS 3.010 and 3.028.

I suspect that will prevent evaperf working properly on the older version...

Cheers,

Rob