Disk Enclosures
1748130 Members
3620 Online
108758 Solutions
New Discussion юеВ

how to configure the Disk Model 10

 
leyearn
Regular Advisor

how to configure the Disk Model 10

Now there is one disk model 10
the configuration line(serial line) is connected between the disk array and pc
addtional specific software is needed or not

if super vitual termialis ok ,something specific should be done?
why there is no reponse if i connect the diskarray by super vitual terminal?
is there something wrong?

thanks
2 REPLIES 2
Mahesh Kumar Malik
Honored Contributor

Re: how to configure the Disk Model 10

Hi

Please check that XON/XOFF and Hardware handshake are set to none on terminal setup.Hope you are using the right serial cable

Regards
Mahesh
Torsten.
Acclaimed Contributor

Re: how to configure the Disk Model 10

I don't remember exactly (long time ago), but try L to refresh the screen, then you should have Grid Managers display.
There is no additional software needed, only a terminal emulation.

Hope this helps!
Regards
Torsten.

__________________________________________________
There are only 10 types of people in the world -
those who understand binary, and those who don't.

__________________________________________________
No support by private messages. Please ask the forum!

If you feel this was helpful please click the KUDOS! thumb below!