Disk Arrays
cancel
Showing results for 
Search instead for 
Did you mean: 

msa1000 a/a controllers

mgentles
Occasional Contributor

msa1000 a/a controllers

Is there not a way to have the LUNs balanced over the 2 controllers when using A/A FW?? It appears that all activity is running through only one currently.

I assume I have to do it from the command line, but anyone have any ideas, or quick links to help me out.

Mike Gentles
2 REPLIES
Crewescontrol
Frequent Advisor

Re: msa1000 a/a controllers

Hi,

It looks like it will depend on the multipath software you have installed (MPIO or SecurePath). This is from the "migrating to active/active controllers in a windows environment". The link direct to the pdf is; http://bizsupport.austin.hp.com/bc/docs/support/SupportManual/c00841968/c00841968.pdf
-------------

"If HP StorageWorks Secure Path for Windows is installed, it can not access or manage HP
StorageWorks active/active MSA1000/1500 disk arrays."

-------------

If it is not in a windows environment, check the follwoing link for the environemnt your are in;

http://h20000.www2.hp.com/bizsupport/TechSupport/DocumentIndex.jsp?contentType=SupportManual〈=en&cc=us&docIndexId=64179&taskId=101&prodTypeId=12169&prodSeriesId=377751

You may have already seen these if you have already upgraded your firmware.

Cheers


Patrick Terlisten
Honored Contributor

Re: msa1000 a/a controllers

Hello Mike,

if you're using HPs full-featured MPIO with the MSA DSM you can change the load-balancing policy in the (hopefully) installed MPIO Manager. Furthermore you assign a LUN to a controller. AFAIK will I/O be done over both paths. If I/O is received over Controller B, but the preferred controller for a LUN is controller A, the I/O will be internally proxied to Controller A. This is called "proxy I/O". You can check this under the MSA controller CLI.

Hope this helps.

Best regards,
Patrick
Best regards,
Patrick