netraid jumpers

[chris_535]

Hello i have a netraid 3si and i`m trying to flash the firmware, it says in the manual i need to short out pins 2-3 of jumper J5. Does anyone have the jumper diagram.

Thanks

Chris

[Michael Schulte zur Sur]

Hi,

couldn't find it either. Can't you find the jumper J5? Usually they are marked on the board and the pin 1 too.

greetings,

Michael

[chris_535]

i can find the pins all of them are open they look like
.....
......

They are to the ltft of the batery but carnt make out the No 1 pin.

[Michael Schulte zur Sur]

Hi,

they should be numbered that way
12345
so look carefully, if there is not a tiny little 1 to the left of the pins.

greetings,

Michael

[e4services]

Email HP support and see if you can get a board layout diagram, since it does not seem to be available anywhere.

[amhakassa]

Hi Chris,

J5 will be right below the internal SCSI Channel 0. It is located besides of J14

Regards
Amha Kassa

[chris_535]

Ive found J5 but need a pin diagram so i know what pins to short to flash the firmware