- Community Home
- >
- Storage
- >
- Entry Storage Systems
- >
- Disk Enclosures
- >
- Re: ompaq Smart Array 4200 Controller
Disk Enclosures
1753460
Members
4548
Online
108794
Solutions
Forums
Categories
Company
Local Language
юдл
back
Forums
Discussions
Forums
- Data Protection and Retention
- Entry Storage Systems
- Legacy
- Midrange and Enterprise Storage
- Storage Networking
- HPE Nimble Storage
Discussions
Discussions
Discussions
Forums
Forums
Discussions
юдл
back
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
- BladeSystem Infrastructure and Application Solutions
- Appliance Servers
- Alpha Servers
- BackOffice Products
- Internet Products
- HPE 9000 and HPE e3000 Servers
- Networking
- Netservers
- Secure OS Software for Linux
- Server Management (Insight Manager 7)
- Windows Server 2003
- Operating System - Tru64 Unix
- ProLiant Deployment and Provisioning
- Linux-Based Community / Regional
- Microsoft System Center Integration
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Blogs
Information
Community
Resources
Community Language
Language
Forums
Blogs
Go to solution
Topic Options
- Subscribe to RSS Feed
- Mark Topic as New
- Mark Topic as Read
- Float this Topic for Current User
- Bookmark
- Subscribe
- Printer Friendly Page
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
тАО10-31-2004 09:04 AM
тАО10-31-2004 09:04 AM
Hello, Im a bit new to SCSI and i was wondering if i would be able to use this Compaq Smart Array 4200 Controller 64bit card in a PowerEdge 1300/700 in a 32bit PCI slot and will be it also be bootable or will i need to have an SCSI or IDE drive on the on-board drive controller to boot. Also will these Quantum Atlas V 9 WLS SCSI drives work connected to the Compaq Smart Array 4200 Controller. Thanks
Solved! Go to Solution.
2 REPLIES 2
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
тАО11-01-2004 12:16 AM
тАО11-01-2004 12:16 AM
Solution
All should be fine. You may need to check the BIOS of the book for boot order, but by default the Controllers BIOS should load and be in the boot process.
You will not need another drive to boot, and the drives seem to be new enought to not be of any problem either.
You will not need another drive to boot, and the drives seem to be new enought to not be of any problem either.
Hot Swap Hard Drives
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
тАО11-01-2004 03:11 AM
тАО11-01-2004 03:11 AM
Re: ompaq Smart Array 4200 Controller
Hello, thanks for the reply, i was wondering since the card is meant to operate 64bit in a 64bit slot, will the performance be as good as a 32bit card, or slightly lower since its meant for 64bit. Thanks
The opinions expressed above are the personal opinions of the authors, not of Hewlett Packard Enterprise. By using this site, you accept the Terms of Use and Rules of Participation.
News and Events
Support
© Copyright 2024 Hewlett Packard Enterprise Development LP