cancel
Showing results for 
Search instead for 
Did you mean: 

pb eVA6000

otmani
Advisor

pb eVA6000

hy

i have a pb with my EVA6000
after power down all compoments (disks,controleur),when i restart it doesn't
start it .i have message tc:0403047F idx:Fl
params 00: 0009a7a8 params 01: 07520100 on panel LCP.
when i start only one controleur same pb
i verify fiber switch channel is ok.
all storage disk are ok.
when i start one controller without storagedisks .i have on panel the wwnn all 0
the controller want a wwnn name.
i think that controleur is ok i think i have a pb of configuration.

thanks for your help

best regards
5 REPLIES
IBaltay
Honored Contributor

Re: pb eVA6000

Hi,
those are the termination events (which caused the controller to halt).
the pain is one part of the reality
otmani
Advisor

Re: pb eVA6000

this messages are on the panel in the menu fault menu

Tc:0403047F idx:FL
params 00: 0009a7a8
params 01: 07520100

thank for help
best
IBaltay
Honored Contributor

Re: pb eVA6000

Hi,
you need to ask the local HP EVA HW support team to give you the root cause analysis - these codes will give them the needed information to decode.
the pain is one part of the reality
IBaltay
Honored Contributor

Re: pb eVA6000

this kind of errors needs to be analyzed by the engineering team
the pain is one part of the reality
Rob Leadbeater
Honored Contributor

Re: pb eVA6000

Hi,

> when i start one controller without storagedisks
> i have on panel the wwnn all 0 the controller want a wwnn name.

That is normal. The configuration for the EVA is stored on the disks, so if you start up the controller without any disks it doesn't know what its WWN is, and prompts you to enter it.

You probably do need to get things analyzed by HP, however you could try powering on the disks first, then just one of the controllers...

Cheers,

Rob