Disk Arrays
cancel
Showing results for 
Search instead for 
Did you mean: 

re : HP model 30 disk array

vinowg
Advisor

re : HP model 30 disk array

Hi Guys,

     Can anyone help, I have a HP model 30 disk array connected to a D-class 380 server via fibre channel. Some how the volume group on the stroage can be mounted. It say IO error. I have check on ioscan and found that the alternate link path is missing . I also do further check with serial link direct to the fc on the array i can see that the disk is rdy by the subsystem fault light is on. when I click enter the information is 18gb disk status unbound and not in group. Is raid 5 . Can anyone advice?? is there anyway I can bring up the lun on vg01, is there any diagnostic test I can do for the array??

 

Regards

Vincent

 

 

 

 

 

2 REPLIES
Torsten.
Acclaimed Contributor

Re: re : HP model 30 disk array

AFAIR you can check with grid manager (serial connection) or directly from SAM.


Hope this helps!
Regards
Torsten.

__________________________________________________
There are only 10 types of people in the world -
those who understand binary, and those who don't.

__________________________________________________
No support by private messages. Please ask the forum!

If you feel this was helpful please click the KUDOS! thumb below!   
Robert_Jewell
Honored Contributor

Re: re : HP model 30 disk array

In addition to attaching directly, you may be able to get a more detailed status of the array by using the STM utility.

 

Try this:

 

 # cstm

cstm> map

Look for the disk array controllers and note the device ID (number in the far left).

cstm> sel dev <#> <#>    (Enter the number for each controller with a space between them)

cstm> info

wait about 10 seconds

cstm>il

 

The info displayed should contain information about the controller, LUNs,  and disk mapping, etc.  Hopefully it gives you more info that you can use to correct your problem.

 

-Bob

----------------
Was this helpful? Like this post by giving me a thumbs up below!