Storage Boards Cleanup
To make it easier to find information about HPE Storage products and solutions, we are doing spring cleaning. This includes consolidation of some older boards, and a simpler structure that more accurately reflects how people use HPE Storage.
Disk Arrays
cancel
Showing results for 
Search instead for 
Did you mean: 

unable to configure VA 7110 with rp5470

Jaweed
Occasional Advisor

unable to configure VA 7110 with rp5470

I'm unable to configure va7110 with rp5470.

My present setup,
2 rp5470 server with 2 HBA's each connected to va 7110 thru HP SAN Switch 2/8-EL (322120-B21) x 2 No.s.

Issues are,
1) There is no link between server and san switch.
2) when connected to san switch thru Hyperterminal....its blank...no information.
No body know the IP for the switch.
3) steps to configure va7110 to rp5470 servers.

I have already installed the Command view "cvsdm_PA_11_23_v10902".

3 REPLIES
Torsten.
Acclaimed Contributor

Re: unable to configure VA 7110 with rp5470

>>"There is no link between server and san switch"

Check cable, GBICs and port speed settings first.

Hope this helps!
Regards
Torsten.

__________________________________________________
There are only 10 types of people in the world -
those who understand binary, and those who don't.

__________________________________________________
No support by private messages. Please ask the forum!

If you feel this was helpful please click the KUDOS! thumb below!   
Jaweed
Occasional Advisor

Re: unable to configure VA 7110 with rp5470

Torsten,

I have checked earlier...No issues with the cable.
Torsten.
Acclaimed Contributor

Re: unable to configure VA 7110 with rp5470

First you need a link!

Did you already check the speed settings on switch and array?

Hope this helps!
Regards
Torsten.

__________________________________________________
There are only 10 types of people in the world -
those who understand binary, and those who don't.

__________________________________________________
No support by private messages. Please ask the forum!

If you feel this was helpful please click the KUDOS! thumb below!