Disk Arrays
cancel
Showing results for 
Search instead for 
Did you mean: 

update mraidnt.sys

John Eddy
Occasional Contributor

update mraidnt.sys

I've scanned through the forum and I've seen this mentioned, but without an answer so here it comes again: I want to update mraidnt.sys on my LPr, but when I go to the scsi devices applet in control panel the only driver listed is the standard atapi 1.2 CD-ROM driver. mraidnt is listed as a scsi device, but there is no option to remove/replace the driver. How do I do this safely?
1 REPLY
RAMY NAGUIB
Frequent Advisor

Re: update mraidnt.sys

1-Insert the NT cd and boot from it like you are doing a recovery.
2-At nt inspecting H/W press F6 then choose other devices and choose have disk and insert the new driver .
3-Complete a repair process without choosing anything to repaire.
Of course a good backup should be available on hand in case of anything goes wrong.
Good Luck