Disk Enclosures
1747984 Members
4646 Online
108756 Solutions
New Discussion юеВ

what is the good command to verify load balance on securepath sp3

 
Hanry Zhou
Super Advisor

what is the good command to verify load balance on securepath sp3

Thanks,
none
3 REPLIES 3
Torsten.
Acclaimed Contributor

Re: what is the good command to verify load balance on securepath sp3

I did not work so much with this, but I would try

# spmgr display

first.

Hope this helps!
Regards
Torsten.

__________________________________________________
There are only 10 types of people in the world -
those who understand binary, and those who don't.

__________________________________________________
No support by private messages. Please ask the forum!

If you feel this was helpful please click the KUDOS! thumb below!   
Denver Osborn
Honored Contributor

Re: what is the good command to verify load balance on securepath sp3

autopath display

Look for "Load Balancing Policy"

To set the load balance policy for round robin...

"autopath set_lbpolicy RR /dev/dsk/cXtXdX"

man autopath for details.

If you want to test and see that it's balancing among all configured paths, you could run a dd to read from one device then pull up 'glance -u' to verify it's spread across all the paths

-denver
Steven E. Protter
Exalted Contributor

Re: what is the good command to verify load balance on securepath sp3

Shalom,

by disk check the sar commands related to disk and buffers

http://www.hpux.ws/?p=6

SEP
Steven E Protter
Owner of ISN Corporation
http://isnamerica.com
http://hpuxconsulting.com
Sponsor: http://hpux.ws
Twitter: http://twitter.com/hpuxlinux
Founder http://newdatacloud.com