Storage Boards Cleanup
To make it easier to find information about HPE Storage products and solutions, we are doing spring cleaning. This includes consolidation of some older boards, and a simpler structure that more accurately reflects how people use HPE Storage.
Disk-Based Backup
cancel
Showing results for 
Search instead for 
Did you mean: 

I was Trying to Update VLS 6870 to 1.1.0, now I could not form again ether 0.

Eduardo Soto Clemente
Occasional Contributor

I was Trying to Update VLS 6870 to 1.1.0, now I could not form again ether 0.

Hi,

After i finished Update firmware 1.1.0,I could not form again the ether 0, at the library.
someone has information how i could set the ip address at the lan.

someone know if there where an issue with the new version of firmware??

Library was working correctly before update,

Best Regard,

Eduardo Soto
3 REPLIES
Rob O'Reilly
Advisor

Re: I was Trying to Update VLS 6870 to 1.1.0, now I could not form again ether 0.

Hello,,

Please refer to this Customer Notice and see if it helps.

Document ID is c00882126


Thanks,
Rob O.

Eduardo Soto Clemente
Occasional Contributor

Re: I was Trying to Update VLS 6870 to 1.1.0, now I could not form again ether 0.

I read the document, and was clear to me.
We need to set all the values, not only 1 or 2, the process is put all values before to do the command: commitConfig.

The problem was save and the library is workink properly again

Tks for your help,

Best regards,

Eduardo Soto
Eduardo Soto Clemente
Occasional Contributor

Re: I was Trying to Update VLS 6870 to 1.1.0, now I could not form again ether 0.

The las commnent was solution.Thanks for your help
eduardo Soto