Disk Enclosures
cancel
Showing results for 
Search instead for 
Did you mean: 

12H Autoraid contrroller

Robert Artus
Occasional Visitor

12H Autoraid contrroller

The X controller in array malfunctioned. I removed it, all was OK on one controller. I installed a replacement and my application was acting like data was corrupt and not accessible. Logprint and arraydsp seemed to think everything was OK.
I had to remove X again to regain normalcy.
Now running with one controller.
Any ideas of what the problem could be?
Thank you
Bob
1 REPLY
Torsten.
Acclaimed Contributor

Re: 12H Autoraid contrroller

Hi,

this is old stuff and not so many information was given.
Of course you should remove the batteries from the replacement controller to clear the settings. Once inserted, check the status and the firmware. If needed, sync the controllers firmware, see man arraymgr and related commands.

Hope this helps!
Regards
Torsten.

__________________________________________________
There are only 10 types of people in the world -
those who understand binary, and those who don't.

__________________________________________________
No support by private messages. Please ask the forum!

If you feel this was helpful please click the KUDOS! thumb below!