HPE Community
Disk Enclosures
1752754 Members
5424 Online
108789 Solutions
New Discussion

Re: 1777-slot 1 drive array error after firmware upgrade

 
Ayman Altounji
Valued Contributor

‎02-20-2001 04:00 PM

‎02-20-2001 04:00 PM

1777-slot 1 drive array error after firmware upgrade

I just upgraded the smart-2dh controller to version 4.44. I had no real problem with the previous version. Anyway after the upgrade I get an error:

1777-slot 1 drive array -proliant storage enclosure problem detected
SCSI port 1: interrupt signal inoperative-check SCSI cable.

Nothing has been changed other than the "upgrading" of the firmware on the controller. the system bios is E39 with date 04/19/2000. It has 512 of ram with a 300 mhz proccessor. The system seems to work however, a F1 prompt comes up to continue which is annoying. I must admit the 3000 is a rack mountable unit but currently, it is just sitting on a shelf and not in a rack. The sytem runs fine otherwise. Any help out there?
0 Kudos
Reply
1 REPLY 1
Ayman Altounji
Valued Contributor

‎04-02-2001 04:00 PM

‎04-02-2001 04:00 PM

Re: 1777-slot 1 drive array error after firmware upgrade

Update the firmware on the drives attached to the Array Controller . If error continues have the Array controller replaced .
0 Kudos
Reply
The opinions expressed above are the personal opinions of the authors, not of Hewlett Packard Enterprise. By using this site, you accept the Terms of Use and Rules of Participation.