HPE Community read-only access December 15, 2018
This is a maintenance upgrade. You will be able to read articles and posts, but not post or reply.
Hours:
Dec 15, 4:00 am to 10:00 am UTC
Dec 14, 10:00 pm CST to Dec 15, 4:00 am CST
Dec 14, 8:00 pm PST to Dec 15, 2:00 am PST
Disk Enclosures
cancel
Showing results for 
Search instead for 
Did you mean: 

Add 18GB Drive

 
Ayman Altounji
Valued Contributor

Add 18GB Drive

Proliant 3000
Novell Netware 4.11
Smart 2/DH Array Controller

Currently running Raid5 with 3 18GB Drives in single array(Netware VOL_1). I want to add a single 18GB Drive for a second Netware Volume. I believe I should install the drive, use cpqonlin.nlm to create a second array, and then use install.nlm to create the partition and volume. Is this the correct procedure? Is there a problem with using only one drive in the second array? Please let me know. Thanks for your help in advance.

Rev. Downed the server. Installed the harddrive into the cage. Booted the server. Ran cpqonlin.nlm - cannot see the drive.
1 REPLY
Ayman Altounji
Valued Contributor

Re: Add 18GB Drive

If you downed the server and added the drive , you'll need to run the Array Configuration Utility (offline)and configure the drive on the controller .