Disk Enclosures
1748140 Members
3506 Online
108758 Solutions
New Discussion юеВ

Re: Add Hosts in Command View

 
Howard_24
Advisor

Add Hosts in Command View

Has anyone run into an issue when you add a host under Command View EVA and you enter a IP address it fails with a message down in the left hand corner, error on page. It then fails to add the host. If I enter obtain address with DHCP it will add the host. I'm running Command View 3.2.0.16 and it's an EVA5000 at 3014.

Thanks,

Howard
6 REPLIES 6
florence mathon lermusi
Trusted Contributor

Re: Add Hosts in Command View

Hi Howard,

as i know, the ip you enter in command view is just informal, your problem is probably coming from something else. Did you try to had other host, or did you retry ?
florence mathon lermusi
Trusted Contributor

Re: Add Hosts in Command View

what is your VCS release on your EVA ?
Uwe Zessin
Honored Contributor

Re: Add Hosts in Command View

He wrote it is 3.014. (Sorry, can't help with the problem)
.
florence mathon lermusi
Trusted Contributor

Re: Add Hosts in Command View

sorry for that...

i'm not sure that VCS 3.014 supports command view 3.2 ...

this can be the source of the pb
Uwe Zessin
Honored Contributor

Re: Add Hosts in Command View

But CV-EVA V3.2 supports VCS V3.014.
.
florence mathon lermusi
Trusted Contributor

Re: Add Hosts in Command View

yes that's right...