Email Subscription Notifications Suspended Temporarily
We are in the process of making navigation in the Servers and Operating Systems forums simpler and more direct. While doing this, we have to temporarily suspend email notifications for subscriptions. If you are subscribed to one or more discussion boards or blogs in the community, please check them daily to see new content. Notifications will be turned back on in a few days. We apologize for any inconvenience this may cause. Thanks, Warren_Admin
Disk Enclosures
cancel
Showing results for 
Search instead for 
Did you mean: 

Add Hosts in Command View

Howard_24
Advisor

Add Hosts in Command View

Has anyone run into an issue when you add a host under Command View EVA and you enter a IP address it fails with a message down in the left hand corner, error on page. It then fails to add the host. If I enter obtain address with DHCP it will add the host. I'm running Command View 3.2.0.16 and it's an EVA5000 at 3014.

Thanks,

Howard
6 REPLIES
florence mathon lermusi
Trusted Contributor

Re: Add Hosts in Command View

Hi Howard,

as i know, the ip you enter in command view is just informal, your problem is probably coming from something else. Did you try to had other host, or did you retry ?
florence mathon lermusi
Trusted Contributor

Re: Add Hosts in Command View

what is your VCS release on your EVA ?
Uwe Zessin
Honored Contributor

Re: Add Hosts in Command View

He wrote it is 3.014. (Sorry, can't help with the problem)
.
florence mathon lermusi
Trusted Contributor

Re: Add Hosts in Command View

sorry for that...

i'm not sure that VCS 3.014 supports command view 3.2 ...

this can be the source of the pb
Uwe Zessin
Honored Contributor

Re: Add Hosts in Command View

But CV-EVA V3.2 supports VCS V3.014.
.
florence mathon lermusi
Trusted Contributor

Re: Add Hosts in Command View

yes that's right...