Adding Disk Shelf to MSA1000

[Nelson C]

I will be adding a fully populated 14disk disk-shelf to a MSA1000 that has two controllers running active/active with Linux RH5 and Oracle on top of that. Could someone point me to documentation on how I can add the disk-shelf properly. I can't seem to find anything on HP

[Marcus Schack]

Check in the Maintenance Service Guide...

http://h20000.www2.hp.com/bizsupport/TechSupport/DocumentIndex.jsp?contentType=SupportManual〈=en&cc=us&docIndexId=64179&taskId=101&prodTypeId=12169&prodSeriesId=377751

[Nelson C]

not much info in there unfortunately

[Víctor Cespón]

The MSA1000 base enclosure has room for 14 disks. Then on the back it has two connectors to add two MSA30 with up to 14 disks each.

See: http://forums11.itrc.hp.com/service/forums/questionanswer.do?threadId=656039

[Greybeard]

if you are adding one shelf, check if it has a dual or single port I/O module since a dual port one will split the bus so you will need two cables in order to see all your disks. A single port card will allow two shelves to be connected, one bus each. I prefer one shelf two busses and split mirrors accross the left and right bus. ;)

[Nelson C]

Greybeard, thanks.. its info like that which is difficult to find.

[Uwe Zessin]

MSA1000 units used to come with two short cables, but maybe somebody found a use for them ;-)