Email Subscription Notifications Suspended Temporarily
We are in the process of making navigation in the Servers and Operating Systems forums simpler and more direct. While doing this, we have to temporarily suspend email notifications for subscriptions. If you are subscribed to one or more discussion boards or blogs in the community, please check them daily to see new content. Notifications will be turned back on in a few days. We apologize for any inconvenience this may cause. Thanks, Warren_Admin
Disk Enclosures
cancel
Showing results for 
Search instead for 
Did you mean: 

All my disk are in FAIL status

Blanes
Occasional Visitor

All my disk are in FAIL status

Hi!

I have a LC 3 server with 4 disk

2 x 9gb -> RAID 1
2 x 18gb -> RAID 1

The server are running well until a wirte error appears. We down the server a we go to HP Netraid config. We see:

DISK 0 FAIL (9GB)
DISK 1 ON-LINE (9GB)

DISK 3 ON-LINE (18GB)
DISK 4 ON-LINE (18GB)

With the server powered off, we have reinserted the disk 0... and we have now all the DISK in "FAIL"...

Is possible that we have a RAID card problem and the disk are ok?

what can we do?

regards,
1 REPLY
Peter Godron
Honored Contributor

Re: All my disk are in FAIL status

Hi,
I would agree with your analysis.
It is quite unlikely that all your disks went down at the same time. The common element on your system is the RAID card.
Try replacing the card and restarting.
You could try to switch off RAID and start, but this may lead to data inconsistencies down the line.