HPE Community
Disk Enclosures
1753287 Members
5594 Online
108792 Solutions
New Discussion

Array Accelerator not working

 
Ayman Altounji
Valued Contributor

‎05-07-2001 04:00 PM

‎05-07-2001 04:00 PM

Array Accelerator not working

I just got a new Smart2DH Array Controller along with Proliant 1850R with SCSI-3 Drive Cage Option kit. The Smart-2DH controller is complaining that the there is a parity error in the Array accelerator and the accelerator is permanently disabled. I ran the Array Diagnostic Utility and it said warranty alert and Array Accelerator parity error:21903.

Is the array accelerator supposed to work on Proliant 1850R? If so, is it possible that my controller has a bad array accelerator? Is there any way to test this other than using ADU or ACU? Your pointers are greatly appreciated.
0 Kudos
Reply
1 REPLY 1
Ayman Altounji
Valued Contributor

‎05-07-2001 04:00 PM

‎05-07-2001 04:00 PM

Re: Array Accelerator not working

Try running the ACU, change the Accelerator Ratio from current settings to something else under Controller/Settings. Then save settings. Then go back and reset the Accelerator Ratio to its original setting and save settings again and exit the ACU.

Have a nice day,

Mike
0 Kudos
Reply
The opinions expressed above are the personal opinions of the authors, not of Hewlett Packard Enterprise. By using this site, you accept the Terms of Use and Rules of Participation.