- Community Home
- >
- Storage
- >
- Entry Storage Systems
- >
- Disk Enclosures
- >
- Array p410i logical drive rebuild problem
Categories
Company
Local Language
Forums
Discussions
Forums
- Data Protection and Retention
- Entry Storage Systems
- Legacy
- Midrange and Enterprise Storage
- Storage Networking
- HPE Nimble Storage
Discussions
Discussions
Discussions
Forums
Discussions
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
- BladeSystem Infrastructure and Application Solutions
- Appliance Servers
- Alpha Servers
- BackOffice Products
- Internet Products
- HPE 9000 and HPE e3000 Servers
- Networking
- Netservers
- Secure OS Software for Linux
- Server Management (Insight Manager 7)
- Windows Server 2003
- Operating System - Tru64 Unix
- ProLiant Deployment and Provisioning
- Linux-Based Community / Regional
- Microsoft System Center Integration
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Community
Resources
Forums
Blogs
- Subscribe to RSS Feed
- Mark Topic as New
- Mark Topic as Read
- Float this Topic for Current User
- Bookmark
- Subscribe
- Printer Friendly Page
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
08-05-2013 10:11 PM
08-05-2013 10:11 PM
Array p410i logical drive rebuild problem
I have 4 SAS 147GB hard disk run under raid 1+0, two of them have 'Predictive to fail soon' message (one in Bay 1 and other one in Bay 3), I replace one of them but unable to rebuild. It's stuck at 10%.
I read somewhere it says upgrade the firmware might solve this problem, it that true. Anyone have solution.
Many thanks
- Tags:
- RAID
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
08-08-2013 07:16 AM
08-08-2013 07:16 AM
Re: Array p410i logical drive rebuild problem
The time required for a rebuild time depends on several factors.
Can you check if the cache is enabler or not? It has been noticed that Without cache the rebuild on Smart array P410i will take 12 to 14 minutes per GB. With cache enable the rebuild will take 20 to 30 seconds per GB.
If even after the Cache is enabled rebuilding is stuck or slow. Please, change the rebuild priority.
You may upgrade the firmware to the latest:
You may also refer to ACU User Guide for to manage efficiently: www.hp.com/ctg/Manual/c00709035.pdf