Autoraid 12H

[Sanjiv Sharma_1]

Dear Friends,
We have an autoraid 12H. Recently it was giving trouble like it was reinitialising every 10 minutes.
We found that the X controller was defective.
We have replaced the X controller and the autoraid is working fine. During X controller failure it was working on Y controller.
During the autoraid failure we got a message on the control panel : "Ready
12H_#1"

Even after the replacement of the X controller it is giving the same message.

What does the message( 12H_#1 ) means ?
Our system is working fine.

Thanks in advance.

P.S,. This thread ahs been moved from Disk to Disk array. - Hp Forum Moderator

[Bob Inglis]

I think, but I'm not positive, that your AutoRaid is displaying it's Alias or assigned name. The command: arraymgr -D would give the array a name which would then be displayed on it's front pannel to make it identifiable. This may have been done by service personell to assist them in identifying which array needed service. Reference: MAN page for arraymgr.