HPE Community
Disk Enclosures
1752777 Members
6088 Online
108789 Solutions
New Discussion юеВ

Re: Bad Controller HSV100 on EVA3000

 
Bogdan Milesan
New Member

тАО11-13-2008 03:17 AM

тАО11-13-2008 03:17 AM

Bad Controller HSV100 on EVA3000

One of the HSV100 controller went power off from time to time. It was diagnoze with hw problems and must be replacing. I never replace one. Could somebody guide me pls the steps needed? EVA3000 have 12 virtual servers.

PS: The other controller do not take the primary role !!! Dunno why. The sistem was implemented by other company...
0 Kudos
Reply
2 REPLIES 2
Ivan Ferreira
Honored Contributor

тАО11-13-2008 04:29 AM

тАО11-13-2008 04:29 AM

Re: Bad Controller HSV100 on EVA3000

A lot of information about this topic in the hp storage forum:

http://www.google.com.py/search?hl=es&q=replacing+eva+controller+site%3Aitrc.hp.com&btnG=Buscar+con+Google&lr=
Por que hacerlo dificil si es posible hacerlo facil? - Why do it the hard way, when you can do it the easy way?
0 Kudos
Reply
V├нctor Cesp├│n
Honored Contributor

тАО11-15-2008 04:34 AM

тАО11-15-2008 04:34 AM

Re: Bad Controller HSV100 on EVA3000

If the EVA is correctly installed, you just have to power off the bad controller, disconnect all cables and replace it by the new one connecting all cables on the same ports.

You should have port FP1 from controller A and FP2 from controller B connected to one switch, and the other two ports connected to the other switch.
Then the servers would not lose connection if you power off one controller.
0 Kudos
Reply
The opinions expressed above are the personal opinions of the authors, not of Hewlett Packard Enterprise. By using this site, you accept the Terms of Use and Rules of Participation.