Clustered iSCSI servers for D8000

[Jeremy C]

Two DL360 Gen10 servers (Windows 2019), each cabled to an HPE D8000 disk enclosure via SAS cables.  Both of the servers can see the drives on the D8000.  I want to provision the logical volumes with HPE Smart Storage Administrator and the cluster to recognize those logical volumes as clustered.  When I run cluster validation on the storage I get:
The hardware is not compatible with Storage Spaces Direct (S2D).
Contact the hardware vendor to verify support for Device Identification VPD page 83h SCSI inquiry data.

I do not want to add all the disks from the D8000 as a cluster storage pool because letting windows provision the raid arrays results in terrible performance.

Thanks

[support_s]

System recommended content:

1. HPE D8000 Disk Enclosure

2. HPE D8000 Disk Enclosure Installation and Maintenance Guide

If the above information is helpful, then please click on "Thumbs Up/Kudo" icon.

Thank you for being a HPE community member.

[SanjeevGoyal]

Hello,
 
Please follow the below documents
D8000 Best Practices
https://support.hpe.com/hpesc/public/docDisplay?docLocale=en_US&docId=emr_na-a00069743en_us

D8000 Disk Enclosure Installation and Maintenance Guide
https://support.hpe.com/hpesc/public/docDisplay?docId=a00067471en_us&docLocale=en_US

If you feel this was helpful please click the KUDOS! thumb below and accept the solution.
Regards,