Email Subscription Notifications Suspended Temporarily
We are in the process of making navigation in the Servers and Operating Systems forums simpler and more direct. While doing this, we have to temporarily suspend email notifications for subscriptions. If you are subscribed to one or more discussion boards or blogs in the community, please check them daily to see new content. Notifications will be turned back on in a few days. We apologize for any inconvenience this may cause. Thanks, Warren_Admin
Disk Enclosures
cancel
Showing results for 
Search instead for 
Did you mean: 

Command View 7.0

Grzegorz Szurkało
Occasional Visitor

Command View 7.0

Hi!
I have to upgrade XCS from 6.0 to 6.110 on my EVA4000, but new XCS 6.110 requires HP CommandView EVA 7.0. Where can I get this product?
Thanks in advance,
Grzegorz
7 REPLIES
Rob Leadbeater
Honored Contributor

Re: Command View 7.0

Hi,

I don't believe CV EVA 7.0 is available for download anywhere. If you've got a valid support contract you should be able to ask HP for it...

However if I remember correctly the only change to XCS 6.110 was support for the new EVAs (4100,6100,8100). Therefore you should be able to upgrade to XCS 6.100 and keep CV EVA at its current version...

Hope this helps,

Regards,

Rob
Rob Leadbeater
Honored Contributor
Mark...
Honored Contributor

Re: Command View 7.0

Hi,
Command View 7 is available from HP only. If you have a valid service contract with them then you will get the CD's in the near future. If you do not have a contract then you will need to contact HP - I suspect there will be a charge involved but I do not know how much.
If you are going from XCS 6.0 then you must have a EVA4/6/8K. You do not need to go to XCS 6.110 as this is only for 41/61/81xx product. For other 2nd generation EVA's you get the same functionality from V6.100. For this you do not need CV 7.0.

Check out this recent HP alert:

http://h20000.www2.hp.com/bizsupport/TechSupport/Document.jsp?objectID=c01035871&dimid=1256978157&dicid=alr_jul07&jumpid=em_alerts/us/jul07/all/xbu/emailsubid/mrm/mcc/loc/rbu_category-Advisory(Revised)/alerts

It gives directions to the 6.100 code etc.

Check out this link for cmd vw V6.0.2 which is probably where you want to go.

http://h20000.www2.hp.com/bizsupport/TechSupport/DriverDownload.jsp?prodNameId=3185481〈=en&cc=us&taskId=135&prodClassId=-1&prodTypeId=18964&prodSeriesId=471497

Mark...




if you have nothing useful to say, say nothing...
Mark...
Honored Contributor

Re: Command View 7.0

Hey Rob,
We must both be replying at the same time !!
Mark...
if you have nothing useful to say, say nothing...
Del_3
Trusted Contributor

Re: Command View 7.0

And be aware if you choose to install CV 7 you will have to upgrade Webes if its running on your SMA/SMS. Webes must be version 5 for CV 7.

http://h18023.www1.hp.com/support/svctools/webes/

Grzegorz Szurkało
Occasional Visitor

Re: Command View 7.0

Thx for info! :)
Grzegorz Szurkało
Occasional Visitor

Re: Command View 7.0

.