HPE Community
Disk Enclosures
1753511 Members
5450 Online
108795 Solutions
New Discussion юеВ

Re: Command View no longer works

 
SOLVED
Go to solution
Gregory Locke
Frequent Advisor

тАО07-23-2007 07:05 AM

тАО07-23-2007 07:05 AM

Command View no longer works

Hi All:

i have an rp4440 that used to be names zeus. It is now named hercules. However, when I try to use Command View and access the system (correct current name and IP), and click on the va7410 array it shows zeus as the Host: and I get a Fatal Initialization Error saying "Init error for device:'zeus:00USR00002T2'
Init error:Initial Device Exception
Failed to open target zeus@null:Error logging in: TIMEOUT EXPIRED

Does anybody have an idea where to change that zeus reference to hercules?
0 Kudos
2 REPLIES 2
Torsten.
Acclaimed Contributor

тАО07-23-2007 07:22 AM

тАО07-23-2007 07:22 AM

Solution

Re: Command View no longer works

Check

/opt/sanmgr/hostagent/config/access.dat
/opt/sanmgr/hostagent/config/commIpAddr.txt

Hope this helps!
Regards
Torsten.

__________________________________________________
There are only 10 types of people in the world -
those who understand binary, and those who don't.
__________________________________________________
No support by private messages. Please ask the forum!

If you feel this was helpful please click the KUDOS! thumb below!   
0 Kudos
Gregory Locke
Frequent Advisor

тАО07-23-2007 09:26 AM

тАО07-23-2007 09:26 AM

Re: Command View no longer works

Between help from Torsten and fnding the CommandView manuals, I managed to fix the problem. Thanks to all.
0 Kudos
The opinions expressed above are the personal opinions of the authors, not of Hewlett Packard Enterprise. By using this site, you accept the Terms of Use and Rules of Participation.