D2600 - Drive with no enclosure number on slot 99; missing enclosure ID

[clangren]

Hi -

I purchased a used D2600 enclosure and have installed 12 drives. The enclosure is the only one on the system and is connected to an LSI9280-8e. All seems to be working well but my compulsion for consistency drives me to try to find out why I have ended up with the following output from storcli /c0 show.

My specific question is on the last drive in the list which shows up with no enclosure ID and 99 as its slot. Is there a way to get the drive recognized as being in enclosure 95 and slot 12? 

Thanks for your assistance!

-----------------------------------------------------------------------------------
EID:Slt DID State DG Size Intf Med SED PI SeSz Model Sp Type
-----------------------------------------------------------------------------------
95:1 93 Onln 1 148.5 GB SATA HDD N N 512B ST3160318AS U -
95:2 102 Onln 3 931.0 GB SATA HDD N N 512B WDC WD1003FBYZ-010FB0 U -
95:3 96 Onln 0 465.25 GB SATA HDD N N 512B WDC WD5003ABYX-01WERA1 U -
95:4 94 Onln 2 148.5 GB SATA HDD N N 512B WDC WD1600AAJS-75M0A0 U -
95:5 103 Onln 3 931.0 GB SATA HDD N N 512B WDC WD1003FBYZ-010FB0 U -
95:6 97 Onln 0 465.25 GB SATA HDD N N 512B WDC WD5003ABYX-01WERA1 U -
95:7 101 GHS - 931.0 GB SATA HDD N N 512B WDC WD1003FBYX-01Y7B1 D -
95:8 104 Onln 3 931.0 GB SATA HDD N N 512B WDC WD1003FBYX-01Y7B1 U -
95:9 98 Onln 0 465.25 GB SATA HDD N N 512B WDC WD5003ABYX-01WERA1 U -
95:10 100 GHS - 465.25 GB SATA HDD N N 512B ST3500641AS D -
95:11 105 Onln 3 931.0 GB SATA HDD N N 512B WDC WD1003FBYX-01Y7B1 U -
:99 99 Onln 0 465.25 GB SATA HDD N N 512B WDC WD5003ABYX-01WERA1 U -
-----------------------------------------------------------------------------------

[clangren]

I sure could use some input on this, even if it is "don't worry about it" or "go read this manual rookie". Thanks!!

[Mahesh202]

Hi clangren

Thankyou for coming on HPE Community Forums,

I suggest you to get in touch with the HPE Technical Support for getting assistance on this because, we will have to check the current status of the drive and also need to check the previous event in order to get this sorted out.

Hope this helps.!

Regards
Mahesh202

[clangren]

Mahesh202 > Thanks very much for the input but I do not have a support agreement with HP. I purchased a used 2600 for use in my home network and have the community as my only source of support.

If anyone has any suggestions for an attempt to fix that would be most welcome. Likewise, if there is technical documentation which I can access to assist in troubleshooting that would also be most welcome.

Thanks very much!